200鈩?/div>
卤5%
resistor
PART
MAX2649EVKIT
Ordering Information
TEMP RANGE
-40掳C to +85掳C
IC PACKAGE
2
脳
3 UCSP
TM
Quick Start
The MAX2649 EV kit is fully assembled and factory test-
ed. Follow the instructions in the
Connections and
Setup
section for proper device evaluation.
Test Equipment Required
Table 1 lists the required test equipment to verify the
MAX2649 operation. It is intended as a guide only, and
some substitutions are possible.
Table 1. Test Equipment
EQUIPMENT
RF Signal
Generators
RF Spectrum
Analyzer
Power Supply
Power Meter
Ammeter
Network
Analyzer
DESCRIPTION
Capable of delivering 0dBm of output
power up to 6GHz (HP 8648C or equivalent)
Capable of covering the operating
frequencies of the device as well as a few
harmonics (HP 8561E or equivalent)
Capable of 30mA at +2.7V to +3.6V
Capable of measuring 20dBm
To measure supply current (optional)
To measure small-signal return loss and
gain (optional, HP 8753D or equivalent)
Component Suppliers
SUPPLIER
Murata
Toko
PHONE
800-831-9172
408-432-8281
FAX
814-238-0490
408-943-9790
Connections and Setup
This section provides a step-by-step guide to operate
and test the device鈥檚 functions. Do not turn on DC
power or RF signal generators until all connections are
made.
Testing the Supply Current
1) Connect a DC supply set to +3.0V (through an
ammeter if desired) to the VCC (J3) and GND (J4)
terminals on the EV kit. If available, set the current
limit to 30mA. Do not turn on the supply.
1
UCSP is a trademark of Maxim Integrated Products, Inc.
________________________________________________________________
Maxim Integrated Products
For pricing, delivery, and ordering information, please contact Maxim/Dallas Direct! at
1-888-629-4642, or visit Maxim鈥檚 website at www.maxim-ic.com.
1
2
3
4
