DS1603
Elapsed Time Counter Module
www.dalsemi.com
FEATURES
搂
搂
搂
搂
Two 32鈥揵it counters keep track of real time
and elapsed time
Counters keep track of seconds for over 125
years
Battery powered counter counts seconds from
the time battery is attached until V
BAT
is less
than 2.5 volts
V
CC
powered counter counts seconds while
V
CC
is above 4.25 volts and retains the count
in the absence of V
CC
under battery backup
power
Clear function resets selected counter to 0
Read/Write serial port affords low pin count
Powered internally by a lithium energy cell
that provides over 10 years of operation
1-byte protocol defines read/write, counter
address and software clear function
Self-contained crystal provides an accuracy of
卤2 min per month
Operating temperature range of 0掳C to 70掳C
Low profile SIP module
PIN ASSIGNMENT
V
CC
RST
DQ
NC
CLK
OSC
GND
1
2
3
4
5
6
7
PIN DESCRIPTION
RST
搂
搂
搂
搂
搂
搂
搂
CLK
DQ
GND
V
CC
OSC
NC
- Reset
- Clock
- Data Input/Output
- Ground
- +5 Volts
- 1 Hz Oscillator Output
- No Connect
DESCRIPTION
The DS1603 is a real time clock/elapsed time counter designed to count seconds when V
CC
power is
applied and continually count seconds under battery backup power with an additional counter regardless
of the condition of V
CC
. The continuous counter can be used to derive time of day, week, month, and year
by using a software algorithm. The V
CC
powered counter will automatically record the amount of time
that V
CC
power is applied. This function is particularly useful in determining the operational time of
equipment in which the DS1603 is used. Alternatively, this counter can also be used under software
control to record real time events. Communication to and from the DS1603 takes place via a 3鈥搘ire
serial port. A 1-byte protocol selects read/ write functions, counter clear functions and oscillator trim. The
device contains a 32.768 kHz crystal which will keep track of time to within
卤2
min/mo. An internal
lithium energy source contains enough energy to power the continuous seconds counter for over 10 years.
OPERATION
The main elements of the DS1603 are shown in Figure 1. As shown, communications to and from the
elapsed time counter occur over a 3鈥搘ire serial port. The port is activated by driving
RST
to a high state.
With
RST
at high level 8 bits are loaded into the protocol shift register providing read/write, register
select, register clear, and oscillator trim information. Each bit is serially input on the rising edge of the
1 of 8
080299
1
2
3
4
5
6
7
8
