FPF2123-FPF2125 IntelliMAX鈩?Advanced Load Management Products
August 2005
FPF2123-FPF2125
IntelliMAX鈩?Advanced Load Management Products
Features
1.8 to 5.5V Input Voltage Range
Controlled Turn-On
0.15-1.5A Adjustable Current Limit
Undervoltage Lockout
Thermal Shutdown
<2uA Shutdown Current
Auto Restart
Fast Current limit Response Time
3us to Moderate Over Currents
20ns to Hard Shorts
Fault Blanking
Reverse Current Blocking
General Description
The FPF2123, FPF2124, and FPF2125 are a series of load
switches which provides full protection to systems and loads
which may encounter large current conditions. These devices
contain a 0.125鈩?current-limited P-channel MOSFET which can
operate over an input voltage range of 1.8-5.5V. The current
limit is settable using an external resistor. Internally, current is
prevented from flowing when the MOSFET is off and the output
voltage is higher than the input voltage. Switch control is by a
logic input (ON) capable of interfacing directly with low voltage
control signals. Each part contains thermal shutdown protection
which shuts off the switch to prevent damage to the part when a
continuous over-current condition causes excessive heating.
When the switch current reaches the current limit, the parts
operate in a constant-current mode to prohibit excessive
currents from causing damage. For the FPF2123 and FPF2124
if the constant current condition still persists after 10ms, these
parts will shut off the switch. The FPF2123 has an auto-restart
feature which will turn the switch on again after 160ms if the ON
pin is still active. The FPF2124 does not have this auto-restart
feature so the switch will remain off after a current limit fault until
the ON pin is cycled. The FPF2125 will not turn off after a
current limit fault, but will rather remain in the constant current
mode indefinitely. The minimum current limit is 150mA.
These parts are available in a space-saving 5 pin SOT23
package
Applications
PDAs
Cell Phones
GPS Devices
MP3 Players
Digital Cameras
Peripheral Ports
Hot Swap Supplies
Typical Application Circuit
TO LOAD
V
IN
V
OUT
FPF2123 - FPF2125
OFF ON
ON
GND
ISET
漏2005 Fairchild Semiconductor Corporation
1
www.fairchildsemi.com
FPF2123-FPF2125 Rev. C