PIC18F6520/8520/6620/8620/6720/8720
4.13
Status Register
The Status register, shown in Register 4-3, contains the
arithmetic status of the ALU. The Status register can be
the destination for any instruction, as with any other reg-
ister. If the Status register is the destination for an
instruction that affects the Z, DC, C, OV or N bits, then
the write to these five bits is disabled. These bits are set
or cleared according to the device logic. Therefore, the
result of an instruction with the Status register as
destination may be different than intended.
For example,
CLRF STATUS
will clear the upper three
bits and set the Z bit. This leaves the Status register as
000u u1uu
(where
u
= unchanged).
It is recommended, therefore, that only
BCF, BSF,
SWAPF, MOVFF
and
MOVWF
instructions are used to alter
the Status register, because these instructions do not
affect the Z, C, DC, OV or N bits from the Status regis-
ter. For other instructions not affecting any status bits,
see Table 24-1.
Note:
The C and DC bits operate as a borrow
and digit borrow bit respectively, in
subtraction.
REGISTER 4-3:
STATUS REGISTER
U-0
鈥?/div>
bit 7
U-0
鈥?/div>
U-0
鈥?/div>
R/W-x
N
R/W-x
OV
R/W-x
Z
R/W-x
DC
R/W-x
C
bit 0
bit 7-5
bit 4
Unimplemented:
Read as 鈥?鈥?/div>
N:
Negative bit
This bit is used for signed arithmetic (2鈥檚 complement). It indicates whether the result was
negative (ALU MSB =
1).
1
= Result was negative
0
= Result was positive
OV:
Overflow bit
This bit is used for signed arithmetic (2鈥檚 complement). It indicates an overflow of the
7-bit magnitude, which causes the sign bit (bit 7) to change state.
1
= Overflow occurred for signed arithmetic (in this arithmetic operation)
0
= No overflow occurred
Z:
Zero bit
1
= The result of an arithmetic or logic operation is zero
0
= The result of an arithmetic or logic operation is not zero
DC:
Digit carry/borrow bit
For
ADDWF, ADDLW, SUBLW
and
SUBWF
instructions:
1
= A carry-out from the 4th low-order bit of the result occurred
0
= No carry-out from the 4th low-order bit of the result
Note:
For borrow, the polarity is reversed. A subtraction is executed by adding the
2鈥檚 complement of the second operand. For rotate (RRF,
RLF)
instructions, this bit
is loaded with either bit 4 or bit 3 of the source register.
bit 3
bit 2
bit 1
bit 0
C:
Carry/borrow bit
For
ADDWF, ADDLW, SUBLW
and
SUBWF
instructions:
1
= A carry-out from the Most Significant bit of the result occurred
0
= No carry-out from the Most Significant bit of the result occurred
Note:
For borrow, the polarity is reversed. A subtraction is executed by adding the
2鈥檚 complement of the second operand. For rotate (RRF,
RLF)
instructions, this bit
is loaded with either the high or low-order bit of the source register.
Legend:
R = Readable bit
- n = Value at POR
W = Writable bit
鈥?鈥?= Bit is set
U = Unimplemented bit, read as 鈥?鈥?/div>
鈥?鈥?= Bit is cleared
x = Bit is unknown
铮?/div>
2004 Microchip Technology Inc.
DS39609B-page 59
prev
next
PIC18F6720相关型号PDF文件下载
-
型号
版本
描述
厂商
下载
-
英文版
8-Pin FLASH-Based 8-Bit CMOS Microcontrollers
-
英文版
8-Pin, 8-Bit CMOS Microcontroller with EEPROM Data Memory
MICROCHIP ...
-
英文版
8-Pin, 8-Bit CMOS Microcontroller with A/D Converter and EEP...
MICROCHIP ...
-
英文版
8-Pin, 8-Bit CMOS Microcontrollers
MICROCHIP ...
-
英文版
EPROM Memory Programming Specification
MICROCHIP ...
-
英文版
8-Pin FLASH-Based 8-Bit CMOS Microcontrollers
MICROCHIP ...
-
英文版
Microcontroller
-
英文版
Microcontroller
-
英文版
Microcontroller
ETC
-
英文版
EPROM-Based 8-Bit CMOS Microcontroller
-
英文版
8-Pin, 8-Bit CMOS Microcontrollers
-
英文版
8-Pin, 8-Bit CMOS Microcontrollers
MICROCHIP ...
-
英文版
ETC
-
英文版
EPROM Memory Programming Specification
-
英文版
EPROM Memory Programming Specification
MICROCHIP ...
-
英文版
28-Pin Programmable Mixed Signal Controller
-
英文版
EPROM Memory Programming Specification
-
英文版
Microcontroller
ETC
-
英文版
Microcontroller
ETC
-
英文版
EPROM/ROM-Based 8-Bit CMOS Microcontroller Series