CS5530 Datasheet

  • CS5530

  • National Semiconductor [Geode⑩ CS5530 I/O Companion Multi-...

  • 3339.45KB

  • NSC

扫码查看芯片数据手册

上传产品规格书

PDF预览

Geode鈩?CS5530
Architecture Overview
(Continued)
1.5
POWER MANAGEMENT
The CS5530 integrates advanced power management
features including:
鈥?Idle timers for common system peripherals
鈥?Address trap registers for programmable address
ranges for I/O or memory accesses
鈥?Up to eight programmable GPIOs
鈥?Clock throttling with automatic speedup for the CPU
clock
鈥?Software CPU stop clock
鈥?Zero Volt Suspend/Resume with peripheral shadow
registers
鈥?Dedicated serial bus to/from the GXLV processor
providing CPU power management status
The CS5530 is an ACPI (Advanced Control and Power
Interface) compliant chipset. An ACPI compliant system is
one whose underlying BIOS, device drivers, chipset and
peripherals conform to revision 1.0 or newer of the ACPI
specification. The 鈥淔ixed Feature鈥?and 鈥淕eneral Purpose鈥?/div>
registers are virtual. They are emulated by the SMI han-
dling code rather than existing in physical hardware. To
the ACPI compliant operating system, the SMI-base virtu-
alization is transparent; however, to eliminate unneces-
sary latencies, the ACPI timer exists in physical hardware.
The CS5530 V-ACPI (Virtual ACPI) solution provides the
following support:
鈥?CPU States 鈥?C1, C2
鈥?Sleep States 鈥?S1, S2, S4, S4BIOS, S5
鈥?Embedded Controller (Optional) 鈥?SCI and SWI event
inputs.
鈥?General Purpose Events
鈥?/div>
Fully programmable GPE0
Event Block registers.
1.5.1 GPIO Interface
Eight GPIO pins are provided for general usage in the
system. GPIO[3:0] are dedicated pins and can be config-
ured as inputs or outputs. GPIO[7:4] can be configured as
the upper addresses of the ISA bus, SA[23:20]. All GPIOs
can also be configured to generate an SMI on input edge
transitions.
SDAT_I
SDAT_O
SDATA_IN
SDATA_OUT
The hardware portion of the XpressAUDIO subsystem
can broadly be divided into two categories. Hardware for:
鈥?Transporting streaming audio data to/from the system
memory and an AC97 codec.
鈥?VSA technology support.
1.6.1 AC97 Codec Interface
The CS5530 provides an AC97 Specification Revision
1.3, 2.0, and 2.1 compatible interface. Any AC97 codec
which supports an independent input and output sample
rate conversion interface (e.g., National Semiconductor
LM4548) can be used with the CS5530. This type of
codec will allow for a design which meets the require-
ments for PC97 and PC98-compliant audio as defined by
Microsoft Corporation. Figure 1-2 shows the codec and
CS5530 signal connections. For specifics on the serial
interface, refer to the appropriate codec manufacturer鈥檚
data sheet.
Low latency audio I/O is accomplished by a buffered PCI
bus mastering controller.
External Source
BITCLK
BIT_CLK
24.576 MHz
SYNC
PC_BEEP
AC97
Geode鈩?/div>
CS5530
SYNC
PC_BEEP
Codec
Figure 1-2. AC97 Codec Signal Connections
1.6.2 VSA Technology Support Hardware
The CS5530 I/O companion incorporates the required
hardware in order to support VSA technology for the cap-
ture and playback of audio using an external codec. This
eliminates much of the hardware traditionally associated
with industry standard audio functions.
XpressAUDIO software provides 16-bit compatible sound.
This software is available to OEMs for incorporation into
the system BIOS ROM.
1.6
XPRESSAUDIO
XpressAUDIO in the CS5530 offers a combined hard-
ware/software support solution to meet industry standard
audio requirements. XpressAUDIO uses VSA technology
along with additional hardware features to provide the
necessary support for industry standard 16-bit stereo syn-
thesis and OPL3 emulation.
www.national.com
8
Revision 4.1

CS5530相关型号PDF文件下载

扫码下载APP,
一键连接广大的电子世界。

在线人工客服

买家服务:
卖家服务:
技术客服:

0571-85317607

网站技术支持

13606545031

客服在线时间周一至周五
9:00-17:30

关注官方微信号,
第一时间获取资讯。

建议反馈

联系人:

联系方式:

按住滑块,拖拽到最右边
>>
感谢您向阿库提出的宝贵意见,您的参与是维库提升服务的动力!意见一经采纳,将有感恩红包奉上哦!