鈥?/div>
0
0
LIC2
Line Interface Control 2
31h
6
LIRST
0
0
5
IBPV
0
0
4
TAIS
0
TAIS
PIN 10
3
JACKS
0
JACKS
PIN 46
2
RCCFE
0
0
1
SCLD
0
0
0
CLDS
0
0
Bit 0: Custom Line Driver Select (CLDS).
Setting this bit to a one will redefine the operation of the transmit line driver.
When this bit is set to a one and LIC1.5 = LIC1.6 = LIC1.7 = 0, then the device will generate a square wave at the TTIP and
TRING outputs instead of a normal waveform. When this bit is set to a one and LIC1.5 = LIC1.6 = LIC1.7
鹿
0, then the device
will force TTIP and TRING outputs to become open-drain drivers instead of their normal push-pull operation. This bit should
be set to zero for normal operation of the device.
Note:
This bit should be set = 0 in 64KCC and 6312kHz transmit modes.
Bit 1: Short Circuit Limit Disable (in E1 mode) (SCLD).
Controls the 50mA (rms) current limiter.
Note:
Not applicable in
6312kHz mode.
0 = enable 50mA current limiter
1 = disable 50mA current limiter
Bit 2: Receive Composite Clock Filter Enable (RCCFE).
(64KCC mode only) Setting this bit will enable the PLL filter on
the received 64kHz composite clock.
Note:
the 8kHz and 400Hz output are not filtered.
0 = Receive Composite Clock Filter Disabled
1 = Receive Composite Clock Filter Enabled
Bit 3: Jitter Attenuator Mux (JACKS).
Controls the source for JA CLOCK. This bit is only used in T1 mode.
0 = JA CLOCK sourced from the pre-scaled MCLK
1 = JA CLOCK sourced from internal PLL
Bit 4: Transmit Alarm Indication Signal (TAIS)
0 = transmit an unframed all-ones code
1 = transmit data normally
Bit 5: Insert BPV (IBPV).
A zero-to-one transition on this bit will cause a single BPV to be inserted into the transmit data
stream. Once this bit has been toggled from a zero to a one, the device waits for the next occurrence of three consecutive ones
to insert the BPV. This bit must be cleared and set again for a subsequent error to be inserted.
Note:
This function not
supported in 64KCC and 6312kHz modes.
Bit 6: Line Interface Reset (LIRST).
Setting this bit from a zero to a one will initiate an internal reset that resets the clock
recovery state machine and recenters the jitter attenuator. Normally this bit is only toggled on power-up. Must be cleared and
set again for a subsequent reset.
Bit 7: Unused, must be set = 0 for proper operation.
83 of 124